Эффект Трещины на поверхности, Эффект Кракелюр Базовое и финишное покрытие)

Crackle creationscrack effect on the surface, craquelure effect Applying the main layer step 1): Use outside or in a wellventilated room at temperatures above 10 c and humidity below 85 to ensure proper drying.Do not spray in strong wind and large dust. Cover the surrounding objects to protect against getting paint on them.Clean the surface of the retired paint and rust with an iron brush or sandpaper. Slightly grind the shiny surfaces. Wash the surface with soap and water, rinse and dry.If the painted surface has already been previously covered with paint, try the product for compatibility on an invisible site. To do this, spray a small amount of the main layer step 1) and allow it to dry completely at least half an hour). Then apply a small amount of top layer step 2). If the result meets the requirements, you can continue. If the test area is covered with wrinkles, blown or crumpled, it may be necessary to completely remove the layer of previous paint before using this product.The bottle is actively shrunk for a minute after the ball will be heard rolling inside. Often shake during use. Spray, moving the bottle uniform movements back and forth, holding it vertically at a distance of 2530 cm. From the surface. The swabs should overlap in part. The decorative effect will be more impressive if the main layer seems 34; wet34;, or shiny when applied to the surface. When spraying, the bottle should constantly move and be at the same distance from the surface to ensure uniformity of appearance and pattern. Application: Apply two layers of the main coating with a 15minute gap.Must pass at least half an hour, better than 1 hour, before applying the top layer.At the end of the operation, clean the valve by turning the bottle from top to bottom and holding the spray button for 5 seconds. If the valve is clogged, twisted and removed, rinse it with a solvent, such as white spirite. Do not insert the pin or other items into the channel. Empty bottle throw away, do not burn and do not put in the home garbage compactor. Finish layer step 2): Use outside or in a wellventilated room at temperatures above 10 c and humidity below 85 to ensure proper drying.Do not spray in strong wind and large dust. Cover the surrounding objects to protect against getting paint on them.Make sure that the main layer is completely dry, usually it takes 30 minutes. The bottle is actively shrunk for a minute after the ball will be heard rolling inside. Shake 10 seconds for every 12 minutes during use. Spray, moving the bottle uniform movements back and forth, holding it vertically at a distance of 1520 cm. From the surface and completely covering it with paint. The top layer should seem 34; wet34; or shiny when spraying.To create a small crack pattern, completely cover the main layer with one top layer. To get a pattern of medium size, completely cover the main layer with one top layer and immediately another 23 times go over the painted object, dust the top. To get a large size pattern, completely cover the main layer with one top layer and immediately another 45 times go over the painted object, painting the top. Do not block the second time, so as not to paint the resulting cracks.After 110 minutes, the crack pattern will begin to appear. The top layer dries to the tint for 30 minutes. When working with aerosol products more often shake, flip and blow the can for 5 seconds. For additional protection against moisture and easy cleaning, additionally cover the surface with transparent varnish from American accents Lacquer finish matte for all effects . Before applying this varnish, you should wait at least an hour.At the end of the operation, clean the valve by turning the bottle from top to bottom and holding the spray button for 5 seconds. If the valve is clogged, twisted and removed, rinse it with a solvent, such as white spirite. Do not insert the pin or other items into the channel. Empty bottle to throw away, do not burn.